Thermoset Carbon Fiber Frame – Revel uses a mix of Japanese Toray T700 and T800 fibers in their frames, but the real magic is in the angles. Most bike frames use a selection of 0-, 45-, and 90-degree fibers, since these are the most readily available and easiest to work with. Revel frames are optimized using more 30/60-degree fibers, which, when laid up properly, create stronger and stiffer tubing and shapes, using less material.

Travel – 120mm Front / 115mm Rear

Wheel Size – 29"

Canfield Balance Formula – CBF™ focuses on designing rear suspension around the Center of Curvature (CC). Until now, most suspension systems have focused solely on the instant center. CBF points the chain-line and corresponding drive forces around the top of the chainring through 100 percent of the travel. This results in maximum pedaling efficiency regardless of terrain, where you are in the travel, or what kind of power you’re putting down.

Internal Cable Routing – Revel’s full-carbon tubes are molded in one piece onto the inside of the carbon frame tubes. Not only does this provide structural improvement to the frame, but also allows you to route an entire frame in about a minute. No rattling, no noise, and no fishing cables out of frames.

Titanium Shock Hardware – Because ti is fly. Every Revel frame comes tricked out with titanium shock mount hardware.

UDH – SRAM's UDH derailleur hanger has been incorporated to keep Ranger compatible with the latest and greatest drivetrain technologies.