DRYRIDE™ 2-Layer Printed Polyester Woven Fabric

DRYRIDE™ 2-Layer Nylon Woven Fabric Hood, Yoke, Sleeves & Reinforcement Panels

DRYRIDE 2-Layer Durashell | 10,000 mm Waterproofing / 5,000 g/m² Breathability – DRYRIDE 2-layer fabric features technical waterproofing and breathable properties in a buttery soft yet bomber package.

Thermacore™ Insulation | 100G – Developed for superior warmth-to-weight, Thermacore™ cranks the heat without limiting mobility. Burton offers Thermacore in a variety of weights, and fine-tune the amount of insulation in the body, sleeves, and hood for focused warmth, enhanced breathability, and greater freedom of movement.

Taffeta Lining Mapped with Microfleece Back Panel – Taffeta offers a crisp, high-end feel that is often woven using a mix of synthetic fibers. Its unique hand feel and sheen make it ideal for printing and embossing, and like all Burton linings, it wicks and breathes easy to keep you dry from the inside out.

Regular Fit – Not too tight, not too baggy. Roomy enough for adding layers without constricting movement.

Room-To-Grow™ System – No need to buy junior new outerwear each season with Burton's Room-To-Grow™ system. A quick snip of the red stitching on the lining is all it takes to extend the length of the legs and sleeves and keep up with those guaranteed growth spurts.

Exterior Waistband Adjustment

Adjustable Sleeve Cuffs

Interior Power-Mesh Dump Pocket

Therma-Pocket with Media Port

Zippered Chest Pocket

Zippered Thigh Pocket

Zippered Sleeve Pass Pocket

Zippered Side-Body Vents

Attached Helmet-Compatible Contour Hood with Elastic Hood Gaiter and Crown Adjustment

Anti-scuff Cuffs with Hook and Loop Elevators

Water-Resistant Boot Gaiters

Reinforced Knee Panels

Ticket O-Loop

Glove Loops

bluesign® Approved Product – The bluesign® system unites the entire supply chain to reduce impact on both humans and the planet. bluesign® approved materials are guaranteed to use only safe chemicals and are manufactured to meet the highest standards of natural resource conservation, consumer and worker health, and clean air and water discharge during the manufacturing process.